IO - NAT Per SSID

Edited

Introduction:

This guide will help assist in making the access point NAT an SSID directly which is ideal for guest networks and removes the requirement for a separate DHCP scope on your firewall or network.

 

Process:

Step one:

We will need to firstly create a NAT profile, click on Configuration > NAT Config

mceclip0.png

Once you have clicked this you then need to click "Add" 

mceclip1.png

 

Step two:

Provide the details of what you would like the DHCP range to be and also the lease time

mceclip2.png

Step Three:

Now we need to apply the NAT config to the Access Point Group, click on Configuration > AP Group and select your AP Group.

On the "Advanced" tab ensure your profile is selected under the "NAT Profile" option anc click "Save"

mceclip3.png

Step Four:

Now we can apply the NAT Profile to the SSID by clicking on the SSID tab and create an SSID as normal but ensure NAT is selected under the "Access Mode" and then click save.

mceclip4.png

Conclusion:

You have now configured an SSID with NAT.

Was this article helpful?

Sorry about that! Care to tell us more?

Thanks for the feedback!

There was an issue submitting your feedback
Please check your connection and try again.