Ruckus ICX - Configuration Backup
Edited
Purpose
The purpose of this guide is to demonstrate how to back up the configuration of any ICX switch.
Whilst the below could be used to backup the running-configuration however it is advised that this is not performed as some parts of the configuration are removed therefore it does not provide a full backup.
Pre-Requisite
The switch must have an IP address
TFTP must be install and your device must be able to communicate with the switch
Backup Procedure
copy startup-config tftp [IP Address] [Filename]
To recover the backup and apply it to the switch use the following article Configuration Restoration
Was this article helpful?
Sorry about that! Care to tell us more?